Khi kết nối, một đầu của lõi sợi quang nên được kết nối với thiết bị trước, đầu còn lại phải được định tuyến dọc theo phía bên trái của tủ máy ảnh và phần đuôi phụ phải được quấn thành vòng tròn và quấn bằng băng dính điện, sau đó đầu kia Kết nối thiết bị hoặc giá đỡ ODF. Giá ODF đi vào cáp từ lỗ ở bên trái của giá ODF. Cẩn thận để không có dây bay.
After the patch fiber is terminated, label paper should be attached, and the label should be marked according to the naming requirements. After the label is affixed, rush to register the use of the ODF frame core. For example, if the trunk fiber core is jumpered, the use of the trunk fiber core (the local end and opposite end information written on the label paper) should be recorded and used. Notepad to record. Then, collect the protective caps of the modules and pigtails and put them in the small box at the bottom of the cabinet for future use.
Công việc hoàn thiện sau khi hoàn thành jumper cũng rất quan trọng:
①Test whether the fiber core is connected and whether the jumper target has been completed;
②After confirming that the fiber jumper work is successfully completed, organize the tools on site, and clean up the pigtail packaging bags and other garbage to keep the environment of the equipment room clean and tidy;
③Turn off the lights in the computer room, check again whether there is anything left in the computer room, and lock the door of the computer room when leaving.

Trên trang web - chuẩn bị trước khi dùng dây nhảy bao gồm:
① Untie the pigtail tape, and unfold the two pigtails separately. After they are fully unfolded, the same interfaces are connected together. After straightening, the two jumpers are bundled together with electrical tape;
②If the fiber cores in different computer rooms are jumpered, you can contact the colleagues in the remote computer room by phone first to test whether the pigtails can be used normally, whether the ODF rack surface is wrong, and test whether the optical loss of the cables is normal; if it is the equipment in the computer room where the site is located Interconnect, connect related equipment, and test whether the pigtail can be used normally;
③Use a notepad to copy down the serial number of the module to be used, the length and type of the fiber core to facilitate asset management.






